NAD T 187 Owner's Manual
Also see for T 187: Owner's manualService manual
                                                       | |
Contents
| 
TONE CONTROLSThe T 187 has three Tone Control levels – Treble, Bass and Center Dialog.Bass and Treble controls only affect the low bass and high treble leaving thecritical midrange frequencies free of coloration. The Center Dialog (‘Dialog’in the VFD) control boosts the ‘presence’ of the midrange region improvingintelligibility of speech.These controls allow one to tweak on-the-fly, the frequency responseof the source during playback. The control setting could be adjustedby navigating through the Tone Controls’ OSD menu via a combinationof [ENTER] and [A/S/D/F] keys. The same can be managed directly bypressing the front panel’s TONE button and then rotating the VOLUME knobto select desired setting.Maximum and minimum values for all three Tone Control levels are ±10 dB.‘Tone Defeat’ gives one the choice of varying or completely bypassing thetone control section of the T 187. If ‘Off’ (‘Tone Active’ in the VFD) is selected,the Tone Control circuits are active.Select ‘On’ (‘Tone Defeat’ in the VFD) to bypass the Tone Controls effectivelydefeating the effect of the tone control circuits.ZONE CONTROLSDepending on the settings made at the separate ‘Zone Setup’ menu underthe ‘Setup Menu’ section discussion, the applicable Zone can be configuredand managed via this ‘Zone Controls’ window.Select ‘On’ to activate the applicable Zone. When activated, the Source inputfor the particular Zone can be allocated by selecting through the followinginputs – All enabled Sources, Front Input, Media Player, Tuner and Local.Select ‘Local’ as your selected Zone’s Source input if you wish to enjoy thesame source as the main Zone and allow simultaneous listening, but withfull separate volume levels.If a Zone is set to ‘Off,’ it is deactivated or powered off.‘Volume’ refers to the adjustable secondary Zone 2 Volume level that can beincreased or decreased using the D/F buttons of the HTR 8 or front panel’scorresponding navigation buttons.When a Zone is activated, a corresponding Zone number is illuminatedat the VFD. Zone 2 is always available to be configured at ‘Zone Controls’menu. For Zone 3 and Zone 4 to become available at the ‘Zone Controls’window, their corresponding ‘Mode’ in the ‘Zone Setup’ menu under the‘Setup Menu’ section should be set to ‘Zone (Audio Only).’NOTEThe ZR 7 remote control will only control Zone 2 applications. Zone 3and Zone 4 could be configured and managed at the appropriate ZoneOSD menu using the front panel navigations buttons as well as thecorresponding keys on the HTR 8 remote control.OPERATIONUSING THE T 187 – MAIN MENU14ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine