Powering-On the PhoneTurning the Phone On* Press and HOLD (On-Off) to turn On the phone.The screen displays mMode animation during the powering-on process.After the powering On process, the phone displays the Idle screen.You may need to input your PIN1 code or phone security code (refer to page 15).Turning the Phone Off* Press and HOLD (On-Off) until it powers down. The power down screen displays theNEC High Definition Mobile graphic and the phone powers Off.After powering Off or turning the wireless phone Off, you must wait three seconds beforepowering On.Language DisplayIf the display is showing any language other than your own, proceed as follows:* Press Softkey 1 (Main) to display the Main Menu. Press 1, 2, and 5 to display the Language screen. (See Flag.)Press the appropriate key to select the required language.Press (End) to return to the Idle screen.Frequency BandsThe type of frequency band that you use depends upon your location. (See Flag.)* Press Softkey 1 (Main), 1, 5, and 4 to display Band screen.Press 1 to select the 850/1900 frequency band if you are located in the United States orpress 2 to select the 900/1800 frequency band if you are located in Europe.O Do not remove the battery to turnyour phone Off as this may causeloss of stored information.O The phone supports the abovelanguages and the keyboardsymbols have been chosen forworld-wide operation.O Frequency bands need to bechanged for the wireless phone towork properly when travelingoutside the United States.AT&T WirelessLanguage M12519
