Accepting a Call* Press (Send) or Softkey 1 (Accept) to connect an incoming call.To use quick silent or any key to accept a call, refer to Answer Options on page 30. However, if you already have a call in progress,pressing the any key function does not apply. With a call in progress, you must press (Send) or Softkey 1 (Accept) to answer anincoming call. (See Flag.)Rejecting a Call* Press (End/On-Off) or Softkey 2 (Reject) to reject or ignore the call. The call goes automatically to voicemail depending ifvoicemail is available by your service provider. (See Flag.)Receiving a Call While in an ApplicationIf you receive a call while creating a new message, you can accept or reject the call. When you accept the call, the message closes soyou may answer the call. The text entry for the message is saved and the message is saved in the Message center Drafts folder.If you receive a call while you are in a PIM application (Personal Information Manager, for example typing a phone contact, calendarentry, or a To Do task), you can accept or reject the call. When you accept the call, the application closes so that you may answer thecall. If you accept a call during text entry or editing changes, the text entry and changes are not saved.If you receive a call while you are using the web browser, you can accept or reject the call. When you accept and end the call, the webbrowser screen returns. You are still connected to the last website accessed.Using Features/Application During a CallThere are a number of features and applications that you may use during a call. The ones that you cannot use during a call are listed inthe following table:Phone Settings Screen Settings Call Settings Security SettingsNetwork Settings Other Settings Reset Settings Language SettingDisplay Call Timer Display Call Charge IR Send IR ReceiveVoice Mail Send Email Clock Web BrowserMy Downloads Send MMS Play Voice Memo SynchronizationUnsuccessful Calls/Auto RedialWith Auto redial set On, your phone will try up to 10 times to redial a number if the first attempt is not successful. If the call cannot beconnected, a tone is heard, the display shows an appropriate message, and the phone returns to Idle. The number is automaticallycalled again after a short delay. The phone will try up to 10 times to redial the number. The failure to connect a call can be due tonetwork problems or if the other phone is busy.* Press Softkey 2 (Cancel) to end a redial attempt.O If you already have 2 calls inprogress (whether active, on hold,or mutli-party), a third incoming callcan not be accepted because theSoftkey 1 (Accept) will not bedisplayed on the incoming callscreen.O Do not press (End/On-Off) toreject an incoming call if youalready have 2 calls in progress.Pressing (End/On-Off) with 2calls in progress does not reject anincoming call but will disconnect acall in progress.Accept Reject21
