Release 6.0 289User Guide Chapter 10 Troubleshooting10.4.3 iSCSI Setup Tool Error CodesiSCSI Setup Tool reports how commands have run and error messages to the following log file.Windows%iSMvol%\etc\trace\iSMiSCSISetup.logLinux/opt/iSMvol/etc/trace/iSMiSCSISetup.log1. Error in log file output[Format]The error occurred when the log file was output.(Error code:xxxx)The error is reported by retrieving the error code at the time of executing Windows API functionthrough the GetLastError function.2. Errors in collecting the serial number.[Formats]WindowsFailed to collect the serial number.(Error code:xxxx)LinuxFailed to collect the serial numbers. Error code:xxxxThe message, "The target hasalready been assigned to theinitiator." is displayed.The target which is assigned to initiators already exists.To register the initiator again, delete the LD Set to which theinitiator was added by using the LD Set management of theiSM client, and then run the iSCSI Setup Tool again.The message, "Failed to collect thehost port information. Errorcode:xxxx" is displayed.An error occurs in a process of retrieving the disk arrayinformation.For details, see Section 10.4.3: “iSCSI Setup Tool ErrorCodes”.The message, "Failed to log on to thetarget. Error code:xxxx" is displayed.An error occurred in logging on to the target.For details, see Section 10.4.3: “iSCSI Setup Tool ErrorCodes”.Problem Cause and SolutionError Codes Cause108 The IP address you have specified is used by another networkequipment.109 Target resource does not exist.110 The disk array you have specified is being used by another tool.111 There are multiple disk arrays with the same serial number.112 Disk array could not be found.201 System call failed.
