Release 6.0 72User Guide Chapter 3 Installing the Disk Array System5. Insert an M5 screw through a cable clamp into each of two screw holes on the rear pole of the rackto screw the inner.Orient cable clamps as shown in the figure on the right when attaching them.Figure 3-7: Attaching Inner Rail6. Attach the rail (R) on the right side of the rack by using the same procedure as above.Installation of rack mount kit is now complete.7. Before mounting a unit, attach ear bezels or front bezel clips. If you use an optional front bezel,attach the bezel clips that come with the front bezel as shown in the following illustration. If no frontbezel is used, attach the ear bezels that come with the unit.Both can be attached to the unit by sliding from the side of the unit.
