Programming Manual 2 - 631Program82DescriptionUse Program 82-01 : Incoming Ring Tone to set the incoming ring tones, whichare the tones a user hears when a call rings an extension. These tones aregrouped into four ring tone Ranges (1~4), also called patterns, that consist of acombination of frequencies. (You assign a specific Range to trunks in Program22-03 and to extensions in Program 15-02.) Within each Range there are threefrequency Types: High, Middle and Low. (Service Code 720 allows users tochoose the Type for their incoming calls.) Each Type in turn consists of twofrequencies and the modulation played simultaneously to make up the tone.These frequencies are determined by their Frequency Number selected inItems 1 and 2 (see below). In this program, you assign the two FrequencyNumbers and Modulation for each Type, for each of the four Ranges. Thechart below shows the default Frequency Numbers for each Type in eachRange.Program 82 : Basic Hardware Setup for Extension82-01 : Incoming Ring ToneLevel:MFInput DataIncoming Ringing Tone Number 1 = Pattern 1 (Trunk Incoming)2 = Pattern 2 (Trunk Incoming)3 = Pattern 3 (Trunk Incoming)4 = Pattern 4 (Trunk Incoming)5 = Intercom Incoming Pattern6 = Alarm Sensor Tone PatternRinging Tone Type Number 1 = High2 = Mid3 = LowItemNo. Item Input Data01 Frequency 1 1 = 520Hz2 = 540Hz3 = 660Hz4 = 760Hz5 = 1100Hz6 = 1400Hz7 = 2000Hz02 Frequency 2
