▪ When MULTI is disabled (F3 off):◦ Pressing GROUP then the pad of an unselected Group, or pressing the pad of an unse-lected Sound, sets the focus to that Group/Sound and clears the current Group/Soundselection (only the focused Group/Sound is then selected). The pad lights up.◦ Pressing GROUP then the pad of a selected Group, or pressing the pad of a selectedSound, sets the focus to that Group/Sound without changing the current Group/Soundselection. The pad stays fully lit.▪ When MULTI is enabled (F3 on):◦ Pressing GROUP then the pad of an unselected Group, or pressing the pad of an unse-lected Sound, adds it to the current Group/Sound selection without changing the cur-rent focus. The pad lights up.◦ Pressing GROUP then the pad of a selected Group, or pressing the pad of a selectedSound, unselects it unless it is the focused Group/Sound. For Groups, the pad turnshalf lit; for Sounds, the pad turns half lit (if it contains a Sound) or off (if it is empty).4.2 Managing SoundsThis section describes the global editing functions available for Sounds and Sound slots.Sounds: Sound List or Pad ViewWith the exception of naming Sound slots, all procedures described in the following sectionsare available both in the Sound List and in the Pad view. The Pad view is an alternative repre-sentation of your Sound slots that puts emphasis on their relationship with the pads on yourcontroller.Managing Sounds, Groups, and Your ProjectManaging SoundsMASCHINE MIKRO - Manual - 173
