Element DescriptionSCALE SectionVelocity Adjusts the velocity response of the drum. Available values rangefrom -100.0 % to 100.0 % (default value). At zero (mid course),the drum is played at full velocity, no matter how hard you hit thekeys (or pads). From the mid position, by turning the knob to theright you increase the positive velocity response and make the drummore and more sensitive to the velocities at which you hit the keys/pads. From the mid position, turning the knob to the left as theinverse effect: the harder you hit the key/pad, the softer theresulting drum sound will be.10.5.4 Tom – HighThe High Tom is an acoustic tom that complements the Floor Tom. With very few parameters itprovides a wide range of tom rolls and fills.The parameters described below are presented as they appear in the Control area (Ar-range view). The same parameters are available in the Plug-in panel within the Plug-inStrip (Mix view). See ↑9.4, The Plug-in Strip for more information on this.Main PageElement DescriptionMAIN SectionEngine Selects the engine used in the Tom plug-in. For more informationon the available engines, please refer to section ↑10.5, The Toms.Tune Adjusts the pitch of the drum played by the middle C, measured inMIDI note numbers and cents. Available values range from 57.00(NOTE A2) to 71.00 (NOTE B3). The default value is 57.00.Decay Adjusts the duration of the sound’s tail, measured as a percentage.Available values range from 0.0 to 100.0% (default: 50.0%).Using the DrumsynthsThe TomsMASCHINE MIKRO - Manual - 562
