2. Press F2 (PAT) to access the Pattern Grid settings.3. Turn the Control encoder to adjust the resolution of the Pattern Grid.To disable the Pattern Grid, simply select the OFF value:► To disable the Pattern Grid, hold GRID, press F2 (PAT), and turn the Control encoderfully clockwise to select OFF.You don’t need to explicitly enable the Pattern Grid on your controller: It is enabled assoon as you select a resolution other than OFF.Method 3: Using the Record Prepare ModeThis extra method is very useful if you are about to start a new recording. Indeed, the RecordPrepare mode (accessed by pressing the unlit REC button and holding it) is tightly integratedinto the recording workflow of Control mode. For all details please refer to section ↑7.2.2, TheRecord Prepare Mode.7.1.7 Adjusting the Step Grid and the Nudge GridThe Step Grid defines regularly spaced-out timings (the “steps”) at which your events/notes canbe created, moved, etc. The Step Grid resolution corresponds to the step size, which directlyaffects the precision of all Pattern editing actions, including quantization (see ↑7.4.7, Quantiz-ing Events/Notes section for more on quantization).The Step Grid also affects the step sequencer on your controller: Increasing the StepGrid resolution (i.e. decreasing the step size) will make more steps available in your Pat-tern for placing events. See ↑7.4.2, Creating Events/Notes for more information on thestep sequencer.Working with PatternsPattern BasicsMASCHINE MIKRO - Manual - 322