Tube Mode – Parameter DescriptionCharge In Tube mode the Saturator provides a negative feedback loopthat attenuates the level at the Saturator’s input according tothe amount of low frequencies at its output. This notablyprevents the bass content “polluting” the saturation. TheCharge parameter allows you to adjust the amount of feedback.At 0 (full left) the feedback loop is disabled. Increase theCharge value to strengthen the effect. Higher values additionallygenerate an interesting compression-like effect.Overload Boosts the low frequencies of the input signal. Used togetherwith the Charge parameter (see above) it provides you with apowerful tool to produce a richer, fatter sound.Drive Adjusts the level of the input signal. This directly affects theamount of tube distortion.EQ SectionBypass Enable this button to bypass the EQ section.Bass Adjusts the level of the low frequency band.Treble Adjusts the level of the high frequency band.OUTPUT SectionGain Adjusts the output level of the effect. Use this to compensatefor changes in volume caused by input gain and signalcompression.12.6.4 Analog DistortionThe Analog Distortion be used to add grit to Drums and Percussion, Lead Synths and Guitars.Effect ReferenceDistortion EffectsMASCHINE MIKRO - Manual - 676
