4. Press the pad of your target Group (this can also be in another Group bank, in this casefirst press the Left/Right Arrow button under the display to select the Group bank). If youwant to paste the Group without affecting the existing Groups, press the dim white padafter the last colored pad to create the new Group and automatically paste the copiedGroup there.→ All parameters of the Group (all included Sounds, Group effects, Group’s Channel proper-ties) will be copied (including its Patterns and Clips in the Arranger if you have enabledthe + EVNT option). The copied Group will replace the Group previously at that positionin the Group List.You will notice that once you have pasted the Group, the target pad starts blinking itself, indi-cating that it is ready to be pasted again: Therefore, to duplicate a Group more than once,once you have pressed the source pad you just have to press all the desired target pads in arow.Instead of holding DUPLICATE, you can also pin the Duplicate mode by pressing DU-PLICATE + CONTROL. You can then release DUPLICATE: Your controller will stay in Du-plicate mode until you press DUPLICATE again. See section ↑2.3.6, Pinning a Mode onYour Controller for more information.4.3.7 Moving GroupsYou can reorder Groups via drag-and-drop in the software. It can be helpful to organize yourGroups more conveniently.You can select multiple Groups to move them all at once! See ↑4.1.3, Selecting Multi-ple Sounds or Groups for more information.Moving Groups is performed like moving Sounds:1. Click and hold the Group.Managing Sounds, Groups, and Your ProjectManaging GroupsMASCHINE MIKRO - Manual - 200
