Nilfisk-Advance SC6000 36C Service Manual

Also see for SC6000 1050D: Instructions for use

Contents

Nilfisk-Advance SC6000 36C Service Manual Manual pdf 97 page image

97Service Manual – SC6000 34 - Scrub System, DiscScrub DeckRemoving the scrub deck is a prerequisite to completing other procedures, such as servicing the brushmotors The procedure is the same for all 3 scrub deck types1 For easier access, you may choose to removeone or both Scrub Deck Doors described onpage 962 Remove both Side Squeegees described onpage 963 If available, position a furniture dolly,mechanic’s creeper, or similar wheeledplatform below the scrub deck to make iteasier to roll the deck out from under themachine4 Lower the scrub deck to a neutral positionRefer to the Deck Lift Actuator described onpage 98 for different options to completethis, including if the actuator cannot bepowered5 Loosen the hose clamp and remove thesolution line from the solution solenoid (C)(If the machine is not equipped with eitherEcoFlex or the wash hose option, you couldremove the solution hose back at the solutionfilter, if preferred.6 Disconnect the solution solenoid connector(D) from the solenoid7 Disconnect the scrub brush motor powerconnectors (E)8 Remove the forward link arm retaining clips and pins (A) from the scrub deck You may wish to tie upthe link arms to prevent them from getting caught when you slide the deck out9 Remove the retaining clip and pin from the deck lift linkage (B)• Access to the pin is easiest from either the left-front or right-rear of the scrub area• After the pin is removed, you may wish to raise the lift actuator to keep it out of the way as you slidethe deck in or out from the machine10 Slide the deck toward the rear of the machineso the deck lift linkage will clear the left brushmotor, and then slide the deck out from theright side of the machineNote: During replacement, note thatthere are two right brush motorconnectors, depending on whetherthe machine uses a cylindrical ordisk deck.AABCAA BC DE