Nordson 3000V Series Manual

Contents

InstallationA 1-42E 2000 Nordson CorporationAll rights reserved41-3000VIssued 5/00A3EN-04-[3V-A-AAXP]-123. Determine which SYSTEM SETTINGS feature to customize. Refer toTable A 1-12 for a list of defaults and options for customizing eachfeature.WARNING: Risk of fire. The default for the overtemperaturesetpoint is 218 _C (425 _F). If the Material Safety Data Sheet(MSDS) for your adhesive gives a flash point that is below218 _C (425 _F), be sure to reset the overtemperature setting toat least 42 _C (75 _F) below the flash point.4. See Figure A 1-31. Press the Up key (1) below the Selectordisplay (2) until the number of the feature you want appears on thedisplay. As the feature number changes, the Multipurpose display (3)changes to show the setting of each feature selected.5. Press the Up or Down keys (4) below the Multipurpose display tochange the setting. The display flashes.6. Press the Enter (5) key to save the new setting. The display stopsflashing.41300122 34 51Fig. A 1-31 Changing the Setting of a Selected Feature1. Up key2. Selector display3. Multipurpose display4. Up and Down keys5. Enter key7. Record your setting in the forms provided at the end of this section.Refer to Records of System Settings.8. Repeat steps 4 through 7 for each feature you wish to change.9. To exit the System Setup area, press the MONITOR/SCAN key.Programming SYSTEMSETTINGS Controls (contd.)