Installation A 1-3E 2000 Nordson CorporationAll rights reserved 41-3000VIssued 5/00A3EN-04-[3V-A-AAXP]-12Follow these guidelines when installing wiring to the unit:S Allow enough room to route your electrical service line to the unit.You can use either of the two access holes in the base of the unit forelectrical service. One hole is for rear access and the other is forbottom access.S Route any wires away from AC power lines, solenoid output lines,and electrical equipment such as motors, contacts, and relays.S Make connections with the minimum length of wire needed. A longwire can act as an antenna for electrical noise.The power requirements of your hoses and guns must be determined tomake sure that you do not overload the unit. If your Nordsonrepresentative has not already checked to see that your unit can supportall of the hoses and guns you plan to install, you need to calculate yourhose/gun power requirements now. You also need to check yourcalculations if you change your system configuration or add new hosesand guns.To determine your hose/gun power requirements, refer to CalculatingHose/Gun Capacity at the end of this manual. If you need help with thisprocedure, contact your Nordson representative.Wiring RequirementsHose/Gun Power Requirements