Nordson 3000V Series Manual

Contents

4130227USELINESTORESPEED12PATTERN CONTROL21Installation A 1-65E 2000 Nordson CorporationAll rights reserved 41-3000VIssued 5/00A3EN-04-[3V-A-AAXP]-12After defining and programming a pattern set, you should store it so youcan use it any time you want. Refer to Using a Stored Pattern Set in theOperation section of this manual. You can also replace an existingpattern set with a new one. You can store up to 99 pattern sets.1. If you have not already done so, program your pattern sets. Refer tothe preceding procedure, Programming a Pattern Set.2. See Figure A 1-42. In the System Setup area, press the Move Downkey (1) until the STORE light (2) turns on.3. Check the Multipurpose display. The display flashes the number ofthe next available pattern set. For example, if you have alreadystored three pattern sets in system memory, the Multipurpose displaywill flash the number 4.Fig. A 1-42 Selecting the StoreFunction1. Move Down key2. STORE light4. Determine whether you want to save the pattern set as a new patternset or whether you want to replace an existing pattern set.To¼ Do this¼Save the pattern set as a newpattern setPress the Enter key. TheMultipurpose display stopsflashing.Replace an existing pattern setwith a new pattern setA. Press the Up or Down key belowthe Multipurpose display until thenumber for the pattern set youwant to replace appears. TheMultipurpose display flashes.B. Press the Enter key. TheMultipurpose display stopsflashing.Storing a Pattern Set