ICB Installation Wizard 81All DNs must be configured in the Meridian system.Note: If changes to IP addresses are to be completed to previouslyinstalled ICB4 cards that are currently configured for Dual CardConferences, the card must be changed to Single Card Mode via the BUIprior to making changes to the IP addresses of the cards.Refer to Figure28 "Installation Wizard: Step 1 - Basic Card Settings window" (page 76)Table 16 "Dual Card Meetings parameters" (page 81) describes theparameters, from top to bottom, of the Dual Card Meetings window.Table 16Dual Card Meetings parametersItem DescriptionIP address ofsecondary cardEnter the IP address of the secondary card.Conferenceaccess numberEnter the DN of the dual-card meeting. Callers will dial this number to accessthe dual-card meeting.Chairpersonnumber inprimary cardEnter the chairperson DN for the dual-card meeting. The chairperson uses thisnumber to access the dual-card meeting.Transfer number Enter the DN that the ICB uses to transfer calls from the primary card to thesecondary card. The system hides this number from end users.Link number Enter the DN that the ICB uses to create a voice path between both cards. Thesystem hides this number from end users.Chairpersoncontrol of dualmeetingFor more information see, "Dual-card meeting" (page 109).Full control including secondary card - If this is clicked, the chairpersoncommands apply to both cards. In this case, the maximum conference size ina 64-port card pair is 60 ports.Control of secondary card is limited - If this is clicked, some chairpersoncommands are limited to the primary card (for example, TUI roll call commandand dial out). The maximum conference size in a 64-port card pair is 62 ports.Nortel Communication Server 1000/Communication Server 2100 Solution/Meridian SL-100Nortel Integrated Conference Bridge: Service Implementation FundamentalsNN43001-558/555-4001-135 01.02 StandardICB Release 4 20 June 2007Copyright © 2007, Nortel Networks.
