101Networking Configuration GuideChapter 9Configuring telephony resourcesThe Telephony Resources panel allows you to view and configure the information for the modulesthat support the digital/analog/ISDN lines for the system and the gateways that support the Voiceover IP (VoIP) trunks. This provides a cohesive view of your telephony communications channelsfor the system.The following paths indicate where to configure telephony resources in Element Manager andthrough Telset Administration:• Element Manager: Configuration > Resources > Telephony Resources• Telset interface: **CONFIG > Hardware (you cannot configure VoIP trunks or IPtelephones)The following table provides links to descriptions of each subpanel.Panel Tasks“Telephony Resources table” on page 102 “Managing modules” on page 87“Media bay module panels” on page 104 “Configuring the trunk module parameters” on page 83“Trunk Module Parameters” on page 104“Port details” on page 110“Call-by-Call Service Selection” on page 108Also refer to: “Dialing plan: Private network settings” on page 281“Call security: Remote access packages” on page 439“Provisioning module lines/loops” on page 112“IP telephones” on page 112“IP Terminal Global Settings” on page 113 “Registering Nortel IP telephones” in the TelephonyDevice Installation Guide (NN40020-309)“IP telephone set details” on page 114“Voice over IP trunks” on page 115“Configuring VoIP trunk gateways” on page 381“VoIP interoperability: Gatekeeper configuration” onpage 389“Routing table” on page 116“H323 Settings” on page 118“H323 Media Parameters” on page 122 “Setting up VoIP trunks for fallback” on page 391“SIP Settings” on page 125“SIP Media Parameters” on page 126“SIP URI Map” on page 127Click the navigation tree heading to access general information about user management.
