Chapter 70 Dial Up Interfaces panel 509Networking Configuration Guide4 Enter a logical name in the Interface name field.5 Select the Automatic dialout check box to use this interface for scheduled service. Refer to“Creating an automatic dial-out interface” on page 521.6 Click OK.The interface appears in the Dial-out Interfaces table.Enabling the modem interfaceAn interface must be enabled to function as a backup connection. If the BCM experiences aprimary connection failure, it will dial-out using the dial-up interface configured as the backup.See “WAN failover” on page 513.To enable the modem interface1 Click Configuration > Resources > Dial Up Interfaces.2 On the Dial-out Interfaces tab, select the modem.3 On the Link Parameters tab, enter the Dial-out number for the modem.4 On the Dial-out Interfaces table, select the Enable check box for the modemThe interface is now enabled.To disable the modem interface1 Click Configuration > Resources > Dial Up Interfaces.2 On the Dial-out Interfaces tab, select the modem to disable.3 On the Dial-out Interfaces tab, clear the Enable check box next to the modem.Connecting a modem interfaceInterfaces can be connected manually, or they can be triggered to connect by auto dial-out, see“Creating an automatic dial-out interface” on page 521. Auto dial-out routes can not be added ifthe interface is already manually connected, unless the interface is already connected with autodial-out routes configured.To manually connect the modem interface1 Click Configuration > Resources > Dial Up Interfaces.2 On the Dial-out Interfaces tab, select the interface to connect.3 Select the Enable check box.4 In the IP Address Specification tab, specify the remote IP address to which to connect.5 In the top panel, click Connect.
