172 Chapter 16 Configuring lines: T1-DIDNN40020-603NN40020-603Configuring DID line featuresThe following procedure describes the fields that need to be confirmed or set for these lines. Fordetailed field descriptions, refer to “Configuring lines” on page 129.To configure DID line features1 Confirm or change the settings on the Trunk/Line Data main panel:• Trunk Type: T-1 DID• Name: Identify the line or line function.• Control Set: Identify a DN if you are using this line with scheduling.• Line Type: Define as public if the line is shared, or as Private To (DN) if the line isassigned to a specific telephone.• Prime Set: If you want the line to be answered at another telephone if the line is notanswered at the target telephone, otherwise, choose None.• Pub. Received #: Not applicable.• Priv. Received #: Not applicable.• Distinct Ring: If you want this line to have a special ring, indicate a pattern (2, 3, or 4).• Use remote package: Not applicable.2 Configure the trunk/line data (Properties tab):• Dial mode: The line service will dictate whether this needs to be set to Pulse or Tone(DTMF) dialing.• Loss package: Define the appropriate loss/gain and impedance settings for the line• Signaling: Match this choice with the information supplied by the service provider.• Link at CO: Enable if provider switch provides alternative line when F71 is invoked for anoutgoing call• Line Tuning Digit:3 Configure the Preferences tab:• Auto privacy: If you activate this feature, the line is available only to the telephone thatanswers the call.• Aux. ringer: Use if your system is equipped with an external ringer, you can enable thissetting to allow this line to ring at the external ringer.• ANI number: Enable if the caller number is to be logged. For T1 lines, this only appears ifSignaling is set to WinkStart.• Distinct rings: If you want this line to have a special ring, indicate a pattern (2, 3, 4, orNone).• Voice message center: If the system is using a remote voice mail, select the centerconfigured with the contact number.• Redirect to: If you want to automatically direct calls out of the system to a specifictelephone, such as a headoffice answer attendant, enter that remote number here. Ensurethat you include the proper routing information.
