351Networking Configuration GuideChapter 40Configuring centralized voice mailThe BCM supports voice-mail configuration either from the local source or by accessing a remotevoice mail system located on another BCM, located on a BCM50, or attached to a Meridian 1system. The system can be configured to more than one voice mail system. However, eachtelephone can only be configured to one system.Refer to the following information:• “Local system as host” on page 351• “Meridian system as host” on page 352• “System set up for host system” on page 352• “System set up for satellite systems” on page 353• “Configuring the system for centralized voice mail” on page 355DMS-100/SL100 centralized voice mail: The BCM can also support centralized voice mail on aDMS-100/SL100 switch through a PRI-DMS-100 connection. The system also supportscentralized voice mail on the switch through an indirect connection through an M1, where theDMS-100/SL100 is connected by PRI-DMS-100 to the M1, and the M1 is connected to a BCMthrough a PRI-MCDN connection. The DMS-100/SL100 can use either the Public number orPrivate number of a BCM telephone to designate the mailbox number on the voice mail system.To configure centralized voice mail, the system must be using a CDP dialing plan and be runningon a private network created using either DPNSS (UK profile), PRI SL-1 or VoIP trunking set upwith MCDN. Private network configuration and features are discussed in “Private networking:MCDN over PRI and VoIP” on page 297.Local system as hostA local system that acts as a central voice-mail location must be able to support MCDN. You canadd up to 1000 mailboxes on BCM voice mail, providing you have entered adequate keycodes.CallPilot constraints:• To allow use of the auto attendant feature, you must ensure that the Allow Network Transferscheck box is selected in the CallPilot Manager.• To allow use of voice mail, you must ensure that the Enabled Redirected DN check box isselected in the CallPilot Manager.• A target line must be set up to be answered by the auto attendant. The target line receiveddigits should match the voice mail DN.Note: For centralized voice mail from a DMS-100/SL100 system,configure the BCM dialing plan as either CDP or UDP.
