Nortel CallPilot 150 Installation And Maintenance Manual

Also see for CallPilot 100: Installation and Maintenance Administration guide Quick start guide Administration guide User manual

Contents

Nortel CallPilot 150 Installation And Maintenance Manual Manual pdf 26 page image

26 Chapter 4 Installing CallPilot 100/150P0604218 02CallPilot 100/150 LEDsWhen the CallPilot 100/150 starts up, the LEDs change to indicate where the CallPilot 100/150 isin the start up process. Table 5 shows the order in which the LEDs change and describes what eachstate indicates.When the CallPilot 100/150 is operating, the LEDs indicate the operating status of the CallPilotinterfaces. Table 6 describes the purpose of the LEDs.Table 5 LEDs during startupLEDs Description Indicates1, 2, 3 and 4 turn on. Power is connected to theCallPilot 100/150 and the RAM test isin progress.1, 2, 3 and 4 turn off. RAM test complete.1, 2, 3 and 4 turn on oneat a time starting with 1. The LEDscontinue to cycle on and off in thisorder.The CallPilot 100/150 is beingupgraded.Note: This sequence does not appearevery time you restart CallPilot 100/150.1, 2, 3 and 4 turn on inorder until all of the LEDs are on. TheLEDs then turn off in the same order.The LEDs continue to cycle on and offin this order.The CallPilot 100/150 is booting up.1, 2, 3 and 4 turn off. The CallPilot 100/150 has finishedbooting up.Note: The LEDs then light to indicateTCM connections as described inTable 6.Note: The CallPilot 100 does not have LEDs 3 and 4.