34 Chapter 5 Initializing the CallPilot 100/150P0604218 02Changing the IP address using an Ethernet crossover cableUsing an Ethernet crossover cable, you can connect the CallPilot 100/150 to your computer. Withthis connection, you can use CallPilot Manager to change the CallPilot 100/150 IP address beforeyou connect it to the network.To use an Ethernet crossover cable, your computer must be equipped with a 10/100 BaseTEthernet card and support TCP/IP protocol. Figure 4 shows the connections required.Figure 4 Ethernet crossover cableConnecting the Ethernet crossover cable1 Shut down the computer.2 Attach one end of the Ethernet crossover cable to the Ethernet port on the CallPilot 100/150.3 Connect the other end of the cable to the network interface card on your computer.4 Start the computer.5 Use the Quick Install Wizard to initialize the CallPilot 100/150.For information about how to use the Quick Install Wizard, refer to “Running the Quick InstallWizard” on page 35.Note: If you do not have access to the CallPilot 100/150 through the network, you can usean Ethernet crossover cable to configure all of the CallPilot 100/150 parameters.Note: An Ethernet crossover cable is available as a separately available part. Forinformation about obtaining an Ethernet crossover cable, contact your Nortel Networkssupplier.
