Modem Access 69CallPilot 100/150 Installation and Maintenance Guide3 In the Advanced options box, select the Log on to network option:4 In the Advanced options box, clear the following options:Enable software compressionRequire encrypted passwordRequire data encryptionRecord a log file for this connection5 In the Allowed network protocols box, select the TCP/IP option.6 In the Allowed network protocols box, clear the following options:NetBEUIIPX/SPC Compatible7 Click the TCP/IP Settings button.8 Select the Specify an IP address option.9 In the IP address box, enter the IP address of CallPilot system, but change the last set of digitsto a different number.For example, if the CallPilot IP address is 192.168.0.1, enter 192.168.0.10.10 Clear the following options:Use IP header compressionUse default gateway on remote network11 Click the OK button.12 Click the OK button.Creating a Dial-Up Networking connection on Windows NT 4.01 Click the Start button and then click Programs.2 Click Accessories and then click Dial-Up Networking.The Dial-Up Networking dialog box appears.3 Click the More button and then click Operator assisted or manual dialing.4 Click the New button.5 Enter a name for the CallPilot connection.6 Select the I know all about dial up connections and would prefer to edit the propertiesdirectly option.The Edit Phonebook Entry dialog box appears.7 Refer to “Configuring the Dial-Up Networking TCP/IP parameters on Windows NT 4.0” forinformation about this dialog box.Note: The IP address you enter here is used to identify your computer during themodem connection. It does not affect the LAN configuration of your computer.
