106 Chapter 7 Configuring the CallPilot systemRunning the Configuration WizardNote: You must upgrade CallPilot Manager and CallPilot Reporter ona stand-alone Web server before you proceed. The required files arelocated on the Application CD.Logging on to CallPilot ManagerStep Action1 When the Windows log on screen appears, log on with the defaultpassword (Bvw250).Note: 1. When you run Internet Explorer for the first time you areasked to make IE the default browser for the server. Click Yes.2 Launch Internet Explorer.3 Enter http:///cpmgr in the URLaddress box.Result: The CallPilot Manager Logon Web page appears.4 Run the Configuration Wizard after a successful upgrade and afterthe data has been restored. (The Configuration Wizard is accessedfrom the CallPilot Manager main screen.) The system launches theWeb browser and prompts you to log on to CallPilot Manager. Logon using your existing CallPilot logon information. Enter informationinto the following:• Mailbox Number—Enter your existing mailbox number.• Password—Enter your password.• Server—Specify the name or the IP address of the CallPilotserver that you want to configure. (The server name may havechanged during the upgrade or platform migration.)Note: When you launch Internet Explorer, you may see a boxthat says "M/S IE Enhanced Security config is currently enabledon your server. This advanced level of security reduces risk."Nortel recommends that you do not lower the security level.Nortel also recommends that you do not select the check boxto not show the message again. If you do lower the securitylevel and you try to access a Web site off the server, it may beblocked by the security setting. You do not receive a warning buta blank screen appears.5 Click Login.Result: The system may prompt you to change the password forthe Administrator mailbox.Nortel CallPilotUpgrade and Platform Migration GuideNN44200-400 01.12 Standard5.0 24 April 2009Copyright © 2007–2009, Nortel Networks.