Nortel CallPilot Series Upgrade Manual

Also see for CallPilot 702t: Installation and configuration guide Installation and configuration

Contents

Nortel CallPilot Series Upgrade Manual Manual pdf 73 page image

Installing the CallPilot 5.0 Image 7312 During the reboot sequence, check the version of the BIOS on thetop of the first screen. The BIOS version must be NNCXUA07.Tip: If the BIOS version is not NNCXUA07, then check if the J10 andJ11 jumpers are both in the top position. Power down the server,remove the single board computer (SBC) board, and set the jumpersto the correct position. Follow the electrostatic discharge (ESD) rulesto prevent static electricity from damaging the SBC board.13 Proceed to the next section, "Installing the CallPilot 5.0 Image"(page 73).—End—Installing the CallPilot 5.0 ImageUse the procedures in this section to install the CallPilot 5.0 Image on thevarious platforms.Installing on 201i platformStep Action1 Insert CallPilot Image CD 1 of 3 for the 201i platform into CD orDVD drive.2 Disconnect the CLAN cable that connects the CallPilot 201i serverto the Nortel server subnet. This isolates the system from anyundesired activity from the network, such as virus attacks. Do notreinstall the CLAN cable until you install the antivirus software onthe CallPilot server.3 Restart the CallPilot server (power off the server and then power iton).Result: The server reboots and displays the following prompt: BOOTROM DOS (Default to No in 5 seconds) (Y/N).4 During boot up when prompted to boot into DOS mode, select Y.If this step is missed or N is selected by mistake, restart the serverand try again.Result: They system is booted to DOS and menu is appears.5 Type 1 to select option 1. SCSI CD-ROM and press Enter.6 At the drive A command prompt, navigate to drive Z and run theimage.bat file.Nortel CallPilotUpgrade and Platform Migration GuideNN44200-400 01.12 Standard5.0 24 April 2009Copyright © 2007–2009, Nortel Networks.