Nortel CallPilot Series Upgrade Manual

Also see for CallPilot 702t: Installation and configuration guide Installation and configuration

Contents

Nortel CallPilot Series Upgrade Manual Manual pdf 30 page image

30 Chapter 3 Preparing the system for upgradeRunning the CallPilot 5.0 Upgrade WizardThe CallPilot 5.0 Upgrade Wizard checks if your CallPilot system is ready foran upgrade; it does not make any changes to your system. The CallPilot 5.0Upgrade Wizard analyzes the software and hardware components of yoursystem and helps you prepare for the upgrade. The CallPilot 5.0 UpgradeWizard performs the following tasks:• platform validation (software and hardware)• data validation• keycode validation• system backupThe CallPilot 5.0 Upgrade Wizard has several optional exit points. You canuse them to perform the upgrade preparation tasks in three phases:• Check for platform and software validity in advance of the actualupgrade.• Validate your existing data prior to the upgrade.• Complete the wizard to fully prepare for upgrade.ATTENTIONDo not launch or run programs or utilities during the upgrade.Do not use Windows Explorer to copy files or to scan disk drives during anupgrade as this can cause the upgrade to fail.You can run the CallPilot 5.0 Upgrade Wizard while the CallPilot 2.02 (2.01.27.05),2.5, 3.0, or 4.0 system is fully operational.You can exit the wizard at any point, make the necessary changes to CallPilot,and rerun the CallPilot 5.0 Upgrade Wizard without harming your system.The figures in this chapter are examples and may not match those shown onyour system.Starting the CallPilot 5.0 Upgrade WizardStep Action1 Launch the CallPilot 5.0 Upgrade Wizard by clicking Start >Programs > CallPilot > Upgrade Wizard.Note: While the CallPilot 5.0 Upgrade Wizard runs,all screen information is written to the log file atD:\Nortel\Data\UpgradeWizard.log.Nortel CallPilotUpgrade and Platform Migration GuideNN44200-400 01.12 Standard5.0 24 April 2009Copyright © 2007–2009, Nortel Networks.