Nortel CallPilot Series Upgrade Manual

Also see for CallPilot 702t: Installation and configuration guide Installation and configuration

Contents

Nortel CallPilot Series Upgrade Manual Manual pdf 69 page image

Upgrading the system BIOS 692 Install an MPB96 card in PCI slot 6.3 Install an MPB96 card in PCI slot 9.4 Install a 7-drop CT Bus cable connecting the three MPB96 cards.Note: If a 7-drop CT Bus cable is used in this configuration,ensure that the end connectors are connected to the end cardsand no connector is left dangling at any end of the cable.—End—What is next?Proceed with "1002rp: Updating the system BIOS" (page 71).Upgrading the system BIOS201i: Updating the system BIOSWindows Server 2003 runs correctly on your 201i server only if you upgradethe system BIOS to version 6.0.3. Upgrade the system BIOS before youapply the CallPilot image from the CDs. If your server is running CallPilot3.0 or later, proceed to "Installing the CallPilot 5.0 Image" (page 73).ATTENTIONUpdating the system BIOS erases all data on the hard drive. Perform this steponly after you run the upgrade wizard and back up your data.Step Action1 Turn on the CallPilot server.2 Insert the CallPilot 5.0 Image CD 1 into the CD or DVD drive.3 At the following prompt, press F2 to enter the BIOS setup:Press F2 to enter SETUPResult: The BIOS setup page appears.4 Select Advanced by using the left or right arrow keys.5 Select Installed O/S by using the up or down arrow keys.6 Change the value in the Installed O/S section to Other by pressingthe plus sign or minus sign.7 Press F10.Nortel CallPilotUpgrade and Platform Migration GuideNN44200-400 01.12 Standard5.0 24 April 2009Copyright © 2007–2009, Nortel Networks.