Replacing the tape drive 109Tighten the screws firmly.7 Ensure that all media drive cable connections are secure.Note: Connectors could be dislodged when you slide the harddrive all the way inside the bay.CAUTIONIf the hard drive cable connections are loose, data loss,data corruption, or system malfunction can occur.8 Reinstall the fans (if removed) and upper fan holder foam.• For instructions on reinstalling the fans, see "Install front systemfan" (page 94).• For instructions on replacing the upper fan holder foam, see "Toreplace the upper fan holder foam" (page 88).9 Reinstall the server side cover.10 Reconnect the peripheral device and power cables.11 Power up the server.12 Rebuild the drive in the RAID system pack.The rebuild copies the data from the operating hard drive to the newhard drive. For instructions, see Chapter 10 "RAID operations"(page 121)Result: Hard drive replacement is complete.—End—Replacing the tape driveThe tape drive is preinstalled at the factory. However, if it becomes faulty,follow the procedure in this section to replace it.CAUTIONUse only a tape drive that is supplied by Nortel.Nortel CallPilot703t Server Maintenance and DiagnosticsNN44200-702 01.03 Standard5.0 3 April 2007Copyright © 2007, Nortel Networks Nortel Networks Confidential.
