RAID splitting 1293 In the Logical Devices section, right-click the logical drive, and thenchoose Check Consistency from the pop-up menu.Result: The Check Consistency status dialog appears.Note: The check can take up to 2 hours to complete. You areinformed when it is finished. If any errors are found, a windowwith an error message is displayed.4 Select Configuration → Exit to close the MegaRAID console.Result: An end of session message appears.5 Click OK.—End—RAID splittingEnsure that your system is in full working order and the RAID hardwareconfiguration is set up properly as described on "Configuring RAID usingLSI Elite 1600 controller and Ctrl+M" (page 124).ATTENTIONThe most important thing to verify is that the RAID channel 1 is connected to thefirst hard drive (top as facing the machine) and channel 2 is connected to thesecond drive (bottom). Do that by either opening the lid and following the cablesor by removing one hard drive and observing which drive is marked dead by thesystem. If the drive matches the graphic location on the Windows MegaRAIDconsole, proceed with the next step.Full data backupATTENTIONAs an extra precaution, Nortel recommends that a full system backup beperformed PRIOR to performing a RAID-split. For more information on systembackups, refer to the CallPilot Manager online Help.To split the RAIDATTENTIONBecause the 703t has only one physical drive per channel, the RAID splittingcan be done using the Windows MegaRAID console without risk of CallPilotdatabase corruption.Nortel CallPilot703t Server Maintenance and DiagnosticsNN44200-702 01.03 Standard5.0 3 April 2007Copyright © 2007, Nortel Networks Nortel Networks Confidential.
