124 Chapter 10 RAID operations10 Press Ctrl+Alt+Delete to restart the server.—End—Configuring RAID using LSI Elite 1600 controller and Ctrl+MThe configuration of the RAID card is stored on both the card and on thehard drive, so typically you are not required to reconfigure RAID unless youare making a change to the RAID system (for example, if you replace thehard drives with higher-capacity hard drives).WARNINGNortel strongly recommends that you not perform low levelformatting. Performing low level formatting results in the drivesbecoming unusable.CAUTIONThis procedure requires that the logical drive be initialized. Whenyou initialize the logical drive, all data on the hard drives is erased.Do not perform this procedure unless you are replacing thehard drives, or you are rebuilding the CallPilot system (that is,reinstalling the Windows operating system and CallPilot software).To configure an LSI Elite 1600 RAID systemTo configure RAID, do the following:Step Action1 Turn on the server and press Ctrl+M when prompted during systembootup.Note: The Ctrl+M utility can take up to 1 minute to launch with111U firmware. The system may appear frozen. Do not reset.2 From the Management menu, select Objects and press Enter.3 From the Objects menu select Adapter and press Enter.4 From the Adapter menu select Factory Default.5 Select Yes to confirm the selection and press Enter.6 Press Ctrl+Alt+Delete when prompted to restart system.7 During bootup, press Ctrl+M to re-enter the RAID setup utility.Nortel CallPilot703t Server Maintenance and DiagnosticsNN44200-702 01.03 Standard5.0 3 April 2007Copyright © 2007, Nortel Networks Nortel Networks Confidential.
