Working with the Channel Monitor 69IF you want to stop or start THENRepeat this step for each DSP.only one or several channels thatare associated with a DSPcheck the check box for eachchannel that you want to stop orstart.4 Click Courtesy Stop, Stop, or Start as required.Result: If you clicked Courtesy Stop or Stop, you are asked toconfirm the Courtesy Stop or Stop. Click OK.The selected channels change to idle or on-duty status, accordingto the action you chose.If the buttons are not available, wait a few seconds for the screento refresh:• The Start button is available only when a component is in theIdle state.• The Courtesy Stop and Stop buttons are available only when acomponent is in one of the following states: Idle, Active, RemoteAlarm, Local Alarm.—End—Working with the Channel MonitorThe Channel Monitor shows the status of call channels. The call channelsare the connections between the server and the switch that carry the callsignals to CallPilot.To view or work with call channel statesStep Action1 Run CallPilot Manager and log in.2 In CallPilot Manager, click Maintenance → Channel Monitor.Result: The Channel Monitor screen appears, showing the channelsassociated with each link.Nortel CallPilot703t Server Maintenance and DiagnosticsNN44200-702 01.03 Standard5.0 3 April 2007Copyright © 2007, Nortel Networks Nortel Networks Confidential.
