How to Use FlashScan Poll 2. Program ChangeNFS-640 Programming Manual P/N 51333:B 10/03/2003 45Baud Rate of Serial PortsPrinter Serial PortThe default baud rate of the RS-232 serial printer port is 9600. To change baud rate to 2400, followthese steps:1. From the SYSTEM NORMAL screen, press the ENTER key to display the Program Entry screen, asshown below:2. Press the 1 key. The control panel displays the Enter Password screen, as shown below:3. Enter 2400B and press . The five asterisks that appear when you type in the baud rate willdisappear when you press .4. Press twice to return to the SYSTEM NORMAL screen.5. To switch from 2400 baud to 9600 baud repeat steps 1, 2, and 3 entering “9600B”.CRT Serial PortThe default setting for the serial RS-232 CRT port is “disabled”. To enable the RS-232 CRT port at9600 baud, follow the steps below.Note: The serial RS-232 CRT port can only be enabled in standalone (non-networked) applications. The only baudrate supported is 9600.1. From the SYSTEM NORMAL screen, press the ENTER key to display the Program Entry screen, asshown below:2. Press the 1 key. The control panel displays the Enter Password screen, as shown below:3. Enter CRT96 and press . The five asterisks that appear when you type in the code willdisappear when you press .4. Press twice to return to the SYSTEM NORMAL screen.5. To switch back to the default network mode (no CRT) repeat steps 1, 2, and 3 entering “NOCRT”.1=PROGRAMMING 2=READ STATUS ENTRY(ESCAPE TO ABORT)ENTER PROG OR STAT PASSWORD, THEN ENTER._ (ESCAPE TO ABORT)1=PROGRAMMING 2=READ STATUS ENTRY(ESCAPE TO ABORT)ENTER PROG OR STAT PASSWORD, THEN ENTER._ (ESCAPE TO ABORT)www.PDF-Zoo.com
