G3 Series EtherNet/IP Technical ManualPage 23TDG3EPTM1-1EN 05/09Subject to change without noticewww.numatics.com/g3Subnet Mask Sub-MenuFactory default subnet mask is 255.255.255.0NOTE!SUBNET MASK255.255.255.0SUBNET MASK255.255.255.0SUBNET MASK255.255.255.0SUBNET MASK255.255.255.0ACCEPTMASK Y NSAVE SETTINGSNOW LATERSteps to Set Subnet Mask1. Press the SET button to enter the Subnet Mask sub-menu.2. Press the NEXT button to select the octet that you would like to change.Press the SET button to change the value.3. Press the SET button to scroll through the hundred, tens and ones digits of theoctet.Press the NEXT button to scroll through the valid digits (0-9).Press the SET button to advance through the octet.Press the NEXT button to advance to the next octet, scroll pass the fourthoctect to accept the entire Subnet Mask4. Press the SET button to input the value shown on the display,5. Press the NEXT button to select Yes or No to accept the Subnet Mask shownon the display..c. Selecting No will bring you back to the main Subnet Mask menu.d. Selecting Yes will take you to the following SAVE SETTINGS menu6. Press the NEXT button to select either NOW or LATER.c. Selecting NOW will cause the node to reset and apply the newsetting.d. Selecting LATER will cause the new Address to be saved intemporary memory to allow you to make additional parameterchanges before the node is reset. However, you must ACCEPT thesaved changes before your next power cycle otherwise they will belost.Press the SET button to confirm your choice.
