Numatics G3 Series EtherNet/IP Technical Manual
Also see for G3 Series EtherNet/IP: Technical manualTechnical manual
                                                                                            | |
Contents
| 
G3 Series EtherNet/IP Technical ManualPage 27TDG3EPTM1-1EN 05/09Subject to change without noticewww.numatics.com/g3Advanced Settings - Diagnostic WordDiagnostic Word FormatBYTE Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 00(Comm. Status) Reserved Reserved Reserved Reserved ReservedSub-BusError(1=Error)UnSwitchedPower Status(1=Error)SwitchedPower Status(1=Error)1(Sub-Bus Status)ErrorCodeErrorCodeErrorCodeStationAddressStationAddressStationAddressStationAddressStationAddressDiag. Word Status Settings9. Press the SET button to enter the ADVANCED SETTINGS menu.10. Press the SET button to enter the ADVANCED MENU /SET STATUS.11. Press the NEXT button to scroll to the SET STATUS / DIAG WORDmenu.Press the SET button to enter the SET STATUS / DIAG WORD menu.12. The current state of the parameter is shown.13. Press the SET button to change this parameterUse the NEXT button to scroll through the choices to enable/disable theDiagnostic Word status for.a. ENABLED (Factory Default)b. DISABLEDc. RETURN (this will return you to the SET STATUS menu)Press the SET button to confirm your choice.14. Press Next to confirm the warning message.15. Press the NEXT button to select Yes or No to accept the selectiona. Selecting No will bring you back to the main SET STATUS menu.b. Selecting Yes will take you to the following saved settings menu.Press the SET button to confirm your choice.Save Settings Steps16. Press the NEXT button to select either NOW or LATER.a. Selecting NOW will cause the node to reset and apply the newsetting.b. Selecting LATER will cause the new NODE DIAG selection to besaved in memory, you must Accept the saved changes before yournext power cycle otherwise they will be lost.Press the SET button to confirm your choice.ADVANCEDSETTINGSADVANCED MENUSET STATUSSET STATUSIO STATUSSET STATUSDIAG WORDDIAG WORD.ENABLEDNODE DIAG.DISABLEDNODE DIAG.RETURNINPUT MAPPINGWILL SHIFT!ACCEPTDISABLED Y NSAVE SETTINGSNOW LATERDIAG WORD.ENABLED |
Related manuals for Numatics G3 Series EtherNet/IP
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine