G3 Series EtherNet/IP Technical ManualPage 28TDG3EPTM1-1EN 05/09Subject to change without noticewww.numatics.com/g3Advanced Settings - Fault ActionSee page 72 for more details.Factory Default is “ALL OFF”NOTE!ADVANCED MENUSET FAULT IDLESET FAULT IDLEFAULT ACTIONFAULT ACTIONOFFFAULT ACTIONHOLD LAST STATEFAULT ACTIONRETURNACCEPTOFF H.L.S. Y NSAVE SETTINGSNOW LATERADVANCEDSETTINGSADVANCED MENUSET STATUSFault Action Settings1. Press the SET button to enter the ADVANCED SETTINGS menu.2. Press the NEXT button to scroll to the ADVANCED MENU / SET FAULTIDLE.3. Press the SET button to enter the ADVANCED MENU / SET FAULT IDLE.4. Press the SET button to enter the SET FAULT IDLE / FAULT ACTION menu.5. The current state of the parameter is shown6. Press the SET button to change this parameterPress the NEXT button to scroll the choices for the desired output action duringa fault state.a. OFF (Factory Default)b. HOLD LAST STATEc. RETURN (this will return you to the SET FAULT/IDLE menu)Press the SET button to confirm your choice.7. Press the NEXT button to select Yes or No to accept the selectionPress the SET button to confirm your choicea. Selecting No will bring you back to the main SET FAULT/IDLEmenu.b. Selecting Yes will take you to the following saved settings menu.Save Settings Steps8. Press the NEXT button to select either NOW or LATER.Press the SET button to confirm your choice.a. Selecting NOW will cause the node to reset and apply the new settingb. Selecting LATER will cause the new FAULT ACTION selection to besaved in memory, you must Accept the saved changes before yournext power cycle otherwise they will be lost.Press the SET button to confirm your choice.FAULT ACTIONOFF
