G3 Series EtherNet/IP Technical ManualPage 74TDG3EPTM1-1EN 05/09Subject to change without noticewww.numatics.com/g3Manifold and I/O Data Sizing WorksheetStep1 : Choose appropriate value and place the corresponding Rx and Tx values in the boxes labeled, “Valve Byte Requirements” at the bottomof the page2 : Choose up to sixteen modules to be included on the discrete I/O side of the manifold and place sum of the corresponding input bytes andoutput bytes in the boxes labeled, “Sub-Bus Byte Requirements” at the bottom of the page.3 : Total the input bytes and output bytes values from the boxes labeled “Sub-Bus Byte Requirements” and “Valve Byte Requirements” in theboxes labeled “Total Input and Output Bytes for Manifold. This is the total input and output byte values required for the configuredmanifold.Valve SideStepValve SideInput Bytes (Rx) Output Bytes (Tx)StatusEnabledStatusDisabled1 Up to 32 Solenoid Coils 4 0 4Digital ModulesStepModule No.DescriptionInput Bytes (Rx) Output Bytes (Tx)StatusEnabledStatusDisabled2240-203/204 16 Inputs - Terminal Strip 3 2 0240-205/209 16 Inputs - 8 x 12mm 3 2 0240-206/210 8 Inputs - 8 x 12mm 2 1 0240-207 16 Outputs - 8 x 12mm 2 0 2240-208 8 Outputs - 8 x 12mm 1 0 1240-211 8 Inputs / 8 Outputs - 8 x 12mm 3 1 1240-241 Sub – Bus Valve Output 4 0 4Analog ModulesStepModule No.DescriptionInput Bytes (Rx) Output Bytes (Tx)2 240-212/214 4 Inputs 8 0240-213/215 2 Inputs/ 2 Outputs 4 4Total Input/Output Size CalculationStepModule PositionModel NumberInput Bytes (Rx) Output Bytes (Tx)21 st2nd3rd4th5th6th7th8th9th10th11 th12th13th14th15th16thSub-Bus Byte Requirements:Optional Diagnostic Word: 2 01 Valve Byte Requirements:3 Total Input and Output Bytes for Manifold