G3 Series EtherNet/IP Technical ManualPage 64TDG3EPTM1-1EN 05/09Subject to change without noticewww.numatics.com/g3Node ConfigurationThe “Node Configuration” window can be used to control different parameters within the manifold. Theseparameters include, “IP Address”, “Subnet Mask”, “Gateway Address”, “SMTP Server”, “DHCP/BOOTPenabled”, “MAC Address”, and “COMM Fault/Idle Mode”. “DHCP/BOOTP enabled” is controlled by asingle check mark box. “COMM Fault/Idle Mode” has two options that can be chosen: “Hold last OutputState” and “Turn OFF All Outputs”.Once the changes have been made, left click on the “Update Configuration” button. The “ConfigurationSuccessfully Updated” window will appear. The Ethernet/IP TM node will reset in a few seconds, or theuser may cycle power to enable the new configuration.
