CountingRanger RP253.8 Counting by calling up a saved average piece weightThe compact scales Ranger RP have a total of 100 memory locations for frequentlyused tare values, average piece weights, target weights and target quantities.In the factory setting, the memory locations 41 to 80 are reserved for average pieceweights. The saved average piece weights are also preserved when the scale isswitched off.3.8.1 Saving average piece weights1. Determine the average piece weight in one of the ways described earlier.2. Enter the memory location number (factory setting: 41 ... 80) and keep Mempressed until the confirmation appears in the display, e.g. APW.41.Note If an average piece weight had already been saved under the selected memory loca-tion, the message rEPLACE appears in the display.• To save the new average piece weight, press Yes. The old average piece weightis overwritten.• To abort the save process, press No. The previous memory location assignmentremains valid.3.8.2 Calling up average piece weightsEnter the number of the memory location with the required average piece weight(factory setting: 41 ... 80) and press Mem briefly.The selected reference value is loaded from the memory and appears briefly in thedisplay. The scale determines the number of pieces with the selected referencevalue.3.8.3 Clearing saved average piece weights1. Enter the number of the memory location with the average piece weight to becleared (factory setting: 41 ... 80) and press Mem briefly.The saved average piece weight is displayed.2. Press C within 2 seconds.CLEArED briefly appears in the display. The saved average piece weight iscleared.