Ranger RP64Appendix8 Appendix8.1 Information for certified scales in EC countriesWeighing instruments verified at the place of manufacture bear the preceding mark onthe packing label and green "M" sticker on the descriptive plate. They may be set towork immediately.Weighing instruments which are verified in two steps have no green "M" on thedescriptive plate and bear the preceding identifaction mark on the packing label. Thesecond step of the verification must be carried out by the approved OHAUS Service orby the W&M authorities. Please contact OHAUS Customer Service.The first calibration step of the verification has been carried out at the manufacturingplant. It comprises all tests according to EN45501-8.2.2. Scales with analog connec-tion to the weighing platform require an additional test according to EN45501-3.5.3.3. However, this test is not mandatory if the terminal bears the same serialnumber as the weighing platform.If national regulations in individual countries limit the period of validity of the certifica-tion, the operator of such a scale is himself responsible for its timely re-certification.8.2 Safety checksThe compact scales of the series Ranger RP have been checked by accredited testinginstitutions. They have passed the safety checks listed below and carry the relevanttest symbols. Production is subject to production monitoring by the inspectionoffices.Country Test symbol StandardCanadaUSACAN/CSA-C22.2 No. 1010.1-92UL Std. No. 61010A-1Other countries CB Scheme(no identification)IEC/EN61010-1:2001