OHAUS Ranger RP Instruction Manual

Settings in the menuRanger RP434.6.2 COM1/COM2 -> PRINTER – settings for protocol printoutThis menu item only appears if the mode "Print" or "A.Print" is selected.4.6.3 COM1/COM2 -> PARAMET – communication parameter4.6.4 COM1/COM2 -> RESET COM1/RESET COM2 – resetting serial interface to factorysettings4.6.5 OPTION – configuring optionsIf no option is installed or is not yet configured, N.A. appears in the display.tEmPLat Selecting protocol printoutStdArd • Standard printouttEmPLt1 • Printout in accordance with Template 1tEmPLt2 • Printout in accordance with Template 2ASCi.FmtT Selecting formats for the protocol printoutLINE.Fmt • Line format: MULtI (multi-line) or SINGLE (single-line)LENGtH • Line length: 0 ... 100 characters, appears only with line format MULtISEPArAt • Separator: , ; . / \ _ and space; appears only with line format SINGLEAdd LF • Line feed: 0 ... 9bAUd Selecting baud rate: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400 baudPAritY Selecting parity: 7 none, 8 none, 7 odd, 8 odd, 7 even, 8 evenH.SHAKE Selecting Handshake: NO, XONXOFF, nEt422, nEt485 (network operationas per RS485 standard via the optional RS422/RS485 interface, only for COM1)NET.Addr Assigning network address: 0 ... 31, only for NET 485ChECSuM Activating checksum byte (appears only in TOLEDO Continuous mode)Vcc Switching 5V voltage, e.g. for a bar code reader, on / offSUrE? Confirmation inquiry• Reset interface settings to factory settings with Yes• Do not reset the interface settings with NoEtH.NEt Configuration of the Ethernet interfaceIP.AddrS • Enter IP addressSUBNEt • Enter Subnet addressGAtEWAY • Enter Gateway addressUSb Configuration of the USB interfaceUSb TEST • Test of the USB interface. After the test has been passed, rEAdY appears in thedisplay.