OHAUS Ranger RP Instruction Manual

Settings in the menuRanger RP374.3.10 RESET – resetting scale settings to factory settings4.4 Application settings (APPLICATION)4.4.1 COUNT – settings for countingSUrE? Confirmation inquiry• Reset the scale settings to factory settings with Yes• Do not reset scale settings with NoVAr-SPL Adaptation of the reference quantityON • The reference quantity can be changed in operating modeOFF • Counting only with defined reference quantitiesMin.reFW Monitoring the minimum reference weightOFF • No monitoring of the minimum reference weight97.5, 99.0,99.5• Monitoring the minimum reference weight so that a counting accuracy of97.5 %, 99.0 % or 99.5 % is achievedrEF.OPt Optimizing the average piece weightOFF • No reference optimizationAUtO • Automatic reference optimizationA-SMPL Automatic determination of the average piece weightON • After taring, the average piece weight is determined with the next weight placedon the scale and the displayed reference quantityOFF • No automatic determination of the average piece weightA.CL-APW Automatic clearing of the average piece weightON • When the load is taken off the scale after a counting operation, the average pieceweight is automatically cleared. The next counting operation begins with deter-mining the average piece weight again.OFF • The average piece weight must be cleared manually by pressing CACCurCY Displaying the counting accuracyON • After the average piece weight is determined, the counting accuracy that can beachieved is shown briefly in the display.OFF • No counting accuracy displaytOtAl.Ct Counting on two scalesbULK • Display number of pieces for the parts on the bulk scale onlybOth • Display number of pieces for all parts on the bulk and the reference scale