Settings in the menuRanger RP414.5 Terminal settings (TERMINAL)4.5.1 DEVICE – Sleep mode, energy-saving mode and display backlighting4.5.2 ACCESS – password for Supervisor menu accessSLEEP This menu item only appears on devices in mains operation.When SLEEP is activated, the scale switches off display and backlighting after thetime period set when not in use. The display and backlighting are switched on againat the press of a key or if the weight changes.Possible settings: OFF, 1 min, 3 min, 5 minPWr OFF This menu item only appears on devices in battery operation.When PWr OFF is activated, the device switches itself off automatically afterapprox. 3 minutes when not in use.b.LIGHt Switching the display backlighting on/off.On scales with a battery, the background lighting switches itself off automatically ifthere has been no activity on the scale for 5 seconds.DAtE.tim Setting date and timeDAtE.FOr • Select type of date setting: EU or USDAtE • Enter the date in the selected formattIME • Enter the timeAM.PM • Select AM/PMbEEP Switching beep on/offON Switching on beep on each key pressOFF Switching off beep on each key pressNote This menu item is accessible without a Supervisor password.SUPErVI Password entry for Supervisor menu accessENtER.C Request to enter passwordEnter the password and confirm with YesrEtYPE.C Request to repeat the password entryEnter the password again and confirm with YesNotes • The password can consist of up to 4 characters.• The key Yes must not be part of the password. It is required for confirming thepassword.• The key No may only be used in combination with another key.• If you enter an impermissible code or make a typing error in the repetition,COdE.Err. appears in the display.