OHAUS Ranger RP Instruction Manual

Table of contentsRanger RP3Table of contentsPage1 Introduction .....................................................................................51.1 Safety instructions .............................................................................51.2 Description ......................................................................................61.3 Putting into operation ......................................................................102 Operation ......................................................................................122.1 Switching on and off .......................................................................122.2 Zeroing / Zero point correction ..........................................................122.3 Simple weighing .............................................................................122.4 Weighing with tare ..........................................................................132.5 Displaying the capacity available ......................................................152.6 Dynamic weighing ..........................................................................152.7 Weighing-in to a target weight and checkweighing .............................162.8 Working with identifications .............................................................182.9 Printing results ...............................................................................182.10 Displaying info ...............................................................................192.11 Switching scales .............................................................................192.12 Totalising .......................................................................................202.13 Cleaning ........................................................................................213 Counting .......................................................................................223.1 Counting parts into a container .........................................................223.2 Counting parts out of a container ......................................................233.3 Counting with variable reference quantity ...........................................233.4 Counting with minimum accuracy ....................................................233.5 Reference optimization ....................................................................243.6 Counting with automatic reference determination ................................243.7 Counting with a known average piece weight ....................................243.8 Counting by calling up a saved average piece weight .........................253.9 Counting by calling up a saved target quantity ...................................263.10 Counting with two scales .................................................................274 Settings in the menu ......................................................................294.1 Operating the menu ........................................................................294.2 Overview .......................................................................................314.3 Scale settings (SCALE) ....................................................................344.4 Application settings (APPLICATION) ..................................................374.5 Terminal settings (TERMINAL) ..........................................................414.6 Configuring interfaces (COMMUNICATION) .........................................424.7 Diagnosis and printing out of the menu settings (DIAGNOS) ................465 Interface description ......................................................................485.1 SICS interface commands ................................................................505.2 TOLEDO Continuous mode ..............................................................535.1 OHAUS interface commands ............................................................48