Océ cm3522/cm2522 11-23Utility mode 1111.4 Specifying administrator settingsThis section describes the function and main registration parameters that can be specified after pressing the[Utility/Counter] key, then touching [Administrator Settings].11.4.1 System SettingsPower Save SettingsOutput Settings* 1 If optional separator is installed, "Tray 2" is selected as the factory default.* 2 If optional separator is installed, "Tray 1" is selected as the factory default.2 ReminderThe "Output Tray Settings" parameter is available only if the optional finisher 9356 or separetor isinstalled.When an additional output tray is installed on finisher 9356, the additional output tray is assigned asTray 2, and Tray 2 is assigned as Tray 3, in "Output Taray Setting".[Bin Assignment] only appears if the optional mailbin kit is installed on finisher 9356.The "Bin Assignment" parameter is set to "Tray 2" only if the optional output tray is installed on finisher9356.Date/Time SettingsParameter Description Default SettingLow Power Mode Set-tingsSpecify the desired length of time (between 2 minutes and240 minutes) until the machine enters Power Save mode.15 minutesSleep Mode Settings Specify the desired length of time (between 2 minutes and240 minutes) until the machine enters Sleep mode.20 minutesPower Save Key Select which low power mode is entered when the [PowerSave] key is pressed.• Low Power:The touch panel goes off and the machine enters a modewhere it conserves energy.• Sleep:Although the machine conserves more energy in Sleepmode than in Power Save mode, the machine must warmup when Sleep mode is canceled, therefore taking morepreparation time than Power Save mode.Low PowerEnter Power SaveModeSpecify settings for faxing. For details, refer to the User’sGuide [Network Scan/Fax/Network Fax Operations].NormalParameter Description Default SettingPrint/Fax OutputSettingsSpecify settings for faxing and printing. For details, refer to the User’s Guide [NetworkScan/Fax/Network Fax Operations] and the User’s Guide [Print Operations].Output Tray Set-tingsSelect the finishing tray for each type of job (copies, printouts, re-ports and faxes).Copy: Tray 1* 1Printer: Tray 1* 1Print Reports: Tray 3* 2Fax: Tray 3*2Bin Assignment Select whether or not Tray 1 is specified as mailbin 5 and the option-al output tray is specified as mailbin 6.Not SetShift Output EachJobSelect whether or not printed copies are fed out shifted when "Off-set" is selected while optional finisher or separator is installed.• Yes: Pages are fed out shifted.• No: Pages are fed out without being shifted.YesDescription Default SettingSpecify the current date and time. In addition, the time zone can be set between -12:00and 13:00 (in 30-minute increments).Time Zone: +00:00
