Océ cm3522/cm2522 11-49Utility mode 1111.8 Finisher Adjustment11.8.1 Center Staple Position AdjustmentThe stapling position when printing with the "Center Staple & Fold" setting can be adjusted for each papersize.2 Note[Center Staple Position Adjustment] appears if optional finisher 9355 is installed or optional Finisher9356 is installed with the Saddle stitcher attached.If the angle of the staple must be adjusted, contact your service representative.!DetailFor details on the "Center Staple & Fold" setting, refer to "Binding copies at the center ("CenterStaple" and "Half-Fold" setting / "Center Staple & Fold" setting)" on page 2-72.For the procedure on adjusting the center folding position, refer to "Half-Fold Position" onpage 11-51.0 Adjust the center folding position before adjusting the center stapling position.0 Before making any adjustments, use the "Center Staple & Fold" setting to print a single sample copy.Perform the adjustment while checking the sample that was created.1 Display the Administrator Settings screen.– For details on displaying the Administrator Settings screen, refer to "Displaying the AdministratorSettings screen" on page 11-35.2 Touch [1 System Settings].The System Settings screen appears.3 Touch [7 Expert Adjustment].The Expert Adjustment screen appears.4 Touch [3 Finisher Adjustment].The Finisher Adjustment screen appears.5 Touch [1 Center Staple Position].The Center Staple Position screen appears.Finisher 9356 + Saddle stitcher
