Specifying Settings From the Control Panel 3im7520/im6020 3-77Specifying Settings From the Control Panel Chapter 33.19 Setting Up LDAP SettingsThe LDAP server can be registered and authentication settings can be spec-ified.LDAP Server Registration ParametersThe LDAP server registration parameters are as follows:Setting Up LDAP screen 1/6Setting Up LDAP screen 2/6* When [LDAP Function] is set to “ON” on the Enabling LDAP screen, the [Check Connection] keyis displayed only when [Manual Destination Input] is set to “Allow” on the Security Detailsscreen.Item DescriptionLDAP Server Name Set the LDAP server name to be registered. Use the key-board that appears in the touch panel to type in the servername (up to 32 characters).Max. Search Results Set the maximum number of destinations to display aftersearching. To change the value, press the [C] (clear) key,and then use the keypad to type in the value (between 5and 1000 destinations).Timeout Set the maximum wait time for the search operation. Tochange the value, press the [C] (clear) key, and then use thekeypad to type in the value (between 5 and 300 seconds).Initial Setting for Search Details Specify the initial setting of the search conditions whenperforming a detailed search. For details on specifying thesetting, refer to “Initial Setting for Search Details” onpage 3-84.Check Connection Checks the connection to the LDAP server.Reset All Settings The LDAP server settings can be reset to the default set-tings that were specified at the factory.When a reset confirmation message appears, touch [Yes].Item DescriptionServer Address Sets the IP address of the LDAP server. Use the keyboardthat appears in the touch panel to type in the address (upto 255 characters).Search Base Specify the search starting point in the hierarchicalstructure that is arranged in the LDAP server. Searchers areperformed by also including the lower sub-directories fromthe starting point that was specified. Use the keyboard thatappears in the touch panel to type in the address (up to 255characters).Check Connection* Checks the connection to the LDAP server.Reset All Settings The LDAP server settings can be reset to their factorydefault.When a reset confirmation message appears, touch [Yes].
