Specifying Settings From the Control Panel 3im7520/im6020 3-95Specifying Settings From the Control Panel Chapter 33.22 E-Mail RX (POP) SettingsYou can specify the settings to perform the authentication of the e-mailsender with POP Before SMTP.E-Mail RX (POP) ParametersThe E-Mail RX (POP) parameters are as follows:E-Mail RX (POP) screen 1/2E-Mail RX (POP) screen 2/2POP Detail screenItem DescriptionE-Mail RX Setting Specify whether to enable authentication reception.POP Server Address Specify the address of the POP server to be used for au-thentication reception.For details on specifying the settings, refer to “POP ServerAddress” on page 3-98.Login Name Sets the login name used to connect to the POP server.Use the keyboard that appears in the touch panel to type inthe login name (up to 63 characters).Password Sets the password used to connect to the POP server. Usethe keyboard that appears in the touch panel to type in thepassword (up to 15 characters).Item DescriptionSSL Setting Specify whether to use SSL in the authentication receptiontime. When SSL is used, the content that is sent is encrypt-ed.Port Number (SSL) Specify the port number for using SSL. To change the val-ue, press the [C] (clear) key, and then use the keypad totype in the value (between 1 and 65535).Item DescriptionAPOP Authentication Sets whether to turn on authentication.Port No. Set the port number used to communicate with the POPserver. To change the value, press the [C] (clear) key, andthen use the keypad to type in the value (between 1 and65535).Connection Timeout If the operation delays while receiving the authenticationfrom the POP server, e-mail reception is automaticallyaborted after time elapses. Set the time from the pointwhen the reception stops to the point when the mailreception is to be aborted. To change the value, press the[C] (clear) key, and then use the keypad to type in the value(between 30 and 300 seconds).
