Specifying Settings From the Control Panel 3im7520/im6020 3-87Specifying Settings From the Control Panel Chapter 33.21 E-Mail TX (SMTP) SettingsInformation such as the SMTP server that is required to send the data as ane-mail attachment in Scan mode can be specified. Also, e-mail authentica-tion can be specified.!DetailIf running an antivirus program on the e-mail server, the binary divisionfunction may not be able to be used. For details, ask the network admin-istrator.To receive binary e-mails, an e-mail client that supports receiving sepa-rated e-mail is required. Note that even if separated e-mail is received itmay not be combined depending on the e-mail client being used.E-Mail TX (SMTP) ParametersThe E-Mail TX (SMTP) parameters are as follows:E-Mail TX (SMTP) screen 1/4E-Mail TX (SMTP) screen 2/4Item DescriptionE-mail Send Setting Specify whether to use an e-mail transmission.Scan Send Specify whether to use a scan transmission.Status Notification Function Specify whether to use the status notification function.Total Counter Notifying Func. Specify whether to use the total counter notification func-tion.Detail Setting Specify the SMTP details. For details on specifying the set-ting, refer to “SMTP Detail” on page 3-92.Item DescriptionSMTP Server Address The SMTP server address used to send e-mail can bespecified. For details on specifying the settings, refer to“SMTP Server Address” on page 3-91.Binary Division Sets whether to send large volume of e-mail in small sizesand separated. Use to send data that has exceeded themaximum capacity when the maximum capacity is limitedper e-mail on the e-mail server.Divided Mail Size Sets the divided data size when dividing the data to besent. To change the value, press the [C] (clear) key, andthen use the keypad to type in the value (between 100 and15000 kb).
