8.[Administration] Tab Page[Setup] Item list 1478 [Administration] Tab Page Setting up IPv6You can set the IPv6 protocol to enable the communication over IPv6.Item name Description1 Enable IPv6 Select whether the IPv6 protocol is enabled or disabled. [Disable] is set as the default.2 LLMNR If IPv6 is enabled, select whether LLMNR is enabled or disabled. [Disable] is set as thedefault.3 Link Local Address The automatically generated unique IP Address used for the IPv6 is displayed.4 Manual You assign the IPv6 address, prefix and default gateway manually. In this mode, you canassign one IPv6 address to this equipment.IP Address — Assign the IPv6 address for this equipment. Specify within the range from1:1:1:1:1:1:1:1 to ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff.Prefix Length — Assign the prefix length for the IPv6 address. Specify within the rangefrom 0 to 128. “0” is set as the default.Gateway — Assign the default gateway address. Specify within the range from1:1:1:1:1:1:1:1 to ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff.Use DHCPv6 Server for options — Select this check box to use the optional information(IPv6 address for the DNS server, etc.) which is issued from the DHCPv6 server. When [Manual] is selected, a stateful address cannot be set. If the selected IPv6 address is already assigned, DAD (Duplicate Address Detection) detects it and notifies you on thetouch panel of this equipment.5 Use Stateless Address Use the IPv6 addresses (Stateless addresses) issued from routers. Use DHCPv6 Server for IP Address(M flag) — Use the IPv6 address issued from theDHCPv6 server in the stateless network environment. Use DHCPv6 Server for options(O flag) — Use the optional information (IPv6 addressfor the DNS server, etc.) issued from the DHCPv6 server in the stateless networkenvironment. FQDN Option — The FQDN option is available if Use DHCPv6 Server for IP Addressis selected. Select [Server] or [Client] for [Update Method] if using the FQDN option. IP Address — Stateless Addresses obtained from routers are displayed. Up to 7 IPv6addresses can be retained.When this equipment receives a router advertisement (RA) from a router, of which M flag configuration is "0", the DHCPv6function is disabled. If you change a router advertisement (RA) M flag configuration from "0" to "1", it is necessary to rebootthis equipment to enable the DHCPv6 function.123456
