Useful Operations for Transmission- 16 -13 When all the documents are scanned,press the to select [Scan Complete]and then press .Reference For details on how to stop scanning and to canceltransmission, refer to the User's Manual Basic.Changing the Sender NameYou can specify the sender name to be printed onfaxes you send. You must register a Sendername in advance.Reference Check that [Sender name] is enabled before using thefollowing functions. For details, refer to the User's ManualBasic. Registering a Sender NameYou can register up to three sender names.Memo In the initial fax settings described in the User's ManualBasic, you specify [Sender ID], which is automaticallyregistered to [Sender name 1].1 Press the <SETTING> key.2 Press the to select [Admin Setup]and then press .3 Enter the administrator password.4 Select [Enter] and then press .5 Press the to select [User Install] andthen press .6 Press the to select [TTI Register/Edit] and then press .7 Press the to select a sender's numberand then press .8 Enter a name up to 22 characters.9 Select [Enter] and then press .10 Press the until the start screen appears. Changing the Sender Name Printedon a FaxBy default, the standard sender name is printedon faxes when you enable [Sender Name]. Touse a sender name other than the standardsender name, perform the following procedure.1 Press the <FAX/HOOK> key.2 Check that [Fax] is selected and thenpress to open the fax start screen.3 Press the to select [Fax Functions]and then press .4 Press the to select [TTI Select] andthen press .5 Press the to select a sender name youwan to use and then press .6 Press the until the fax standby screenappears. Changing the Standard SenderNameIf you use a sender name frequently, werecommend to specify it as the standard sendername.Memo In the initial fax settings described in the User's ManualBasic, you specify [Sender ID]. By default, this value isused as the standard sender name.1 Press the <SETTING> key.2 Press the to select [Admin Setup]and then press .3 Enter the administrator password.4 Select [Enter] and then press .5 Press the to select [User Install] andthen press .6 Press the to select [Standard TTI]and then press .7 Press the to select a name you wantto use and then press .8 Press the until the start screenappears.OKOKOKOKOKOKOKOKOKOKOKOKOKOKOKOK
